Montigo HW-Series DF Owner's Manual download pdf (Page 17)

Page 17

HWDF-Series Gas Fireplace

Part No. XG0190 - 071409

Operation - Model HW38DF

WARNING: If you do not follow these instructions exactly, a re or explosion may

result causing property damage, personal injury or loss of life.

■ If you cannot reach your gas supplier, call the Fire

Department.

C. Use only your hand to push in or turn the gas control knob.

Never use tools. If the knob will not push in or turn by hand,

don't try to repair it, call a qualiﬁed service technician. Force

or attempt to repair may result in a ﬁre or explosion.

D. Do not use this appliance if any part has been under water.

Immediately call a qualiﬁed service technician to inspect the

appliance and to replace any part of the control system, and

any gas control which has been under water.

A. This appliance has a pilot which must be lighted by hand.

When lighting the pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all around the appliance area for

gas. Be sure to smell next to the ﬂoor because some gas is

heavier than air and will settle on the ﬂoor.

What To Do If You Smell Gas:

■ Do not try to light any appliance.

■ Do not touch any electrical switch; do not use any phone

in your building.

■ Immediately call your gas supplier from a neighbour's

phone. Follow the gas supplier's instructions.

To Turn Off Gas To Appliance:

3. Push in gas control knob slightly and turn clockwise to

"Oﬀ". Do not force.

4. Flip up the lower trim.

1. Turn oﬀ remote switch.

2. Flip down the lower trim.

1. STOP! Read the safety information above on this label.

2. Flip down the lower trims.

3. Push in gas control knob and turn clockwise

to "OFF."

4. Wait ﬁve (5) minutes to clear out any gas. Smell for gas,

including near the ﬂoor. If you then smell gas, STOP! Follow

"B" in the safety information above on this label. If you don't

smell gas, go to the next step.

5. Locate pilot burner (See illustration at right.) and follow steps

below.

6. Turn knob on gas control counter clockwise

to "PILOT."

7. Push in gas control knob completely and hold. Light with Piezo

Igniter button. Continue to hold the control knob in for about

(1) minute after the pilot is lit. Release the knob and it will pop

back up. Pilot should remain lit. If it goes out repeat steps 3

through 8.

■ If knob does not pop up when released. Stop and immediately

call your service technician or gas supplier.

■ If the pilot will not stay lit after several tries, turn the gas

control knob to "OFF" and call your service technician or

gas supplier.

8. Push in gas control knob and turn counter-clockwise

"ON."

9. Flip up the lower trim.

10.Turn on remote switch to ignite ﬁre.

Lighting Instructions:

with Continuous Pilot

For Your Safety - READ BEFORE LIGHTING:

NOTE: Gas control knob cannot be turned from

"PILOT"to"OFF"unlessknobispushed

in slightly. Do not force.

Gas Control Knob

(Shown in "Pilot" postion.)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comments to this Manuals

No comments

Montigo HW-Series DF Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Fireplaces Montigo HW-Series DF