Montigo HW-Series DF Owner's Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
Page 19
HWDF-Series Gas Fireplace
Part No. XG0190 - 071409
Operation - Model HW38-DF-F
Operation - Model HW38DF-F
To Turn Off Gas To Appliance:
1. Turn off remote switch.
2. Remove the lower Horizontal access panel.
3. Turn the incoming gas control valve to "Off".
4. Replace the lower Horizontal access panel.
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
with Proflame SIT Electronic Ignition
Lighting Instructions:
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand,don'ttrytorepairit,callaqualiedservicetechnician.
Forceorattempttorepairmayresultinareorexplosion.
D. Do not use this appliance if any part has been under
water.Immediatelycallaqualiedservicetechnicianto
inspect the appliance and to replace any part of the control
system, and any gas control which has been under water.
A. This appliance is equipped with an ignition system that
lights the pilot burner automatically. Do not attempt to light
the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for
gas.Besuretosmellnexttotheoorbecausesomegas
isheavierthanairandwillsettleontheoor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any
phone in your building.
Immediatelycallyourgassupplierfromaneighbour's
phone.Followthegassupplier'sinstructions.
If you cannot reach your gas supplier, call the Fire
Department.
1. STOP! Read the safety information above on this label.
2. Remove the lower Horizontal access panel.
3. TurnIncominggasvalvetotheON"position.
4. Wait 5 minutes to clear out any gas. If you smell gas,
STOP!Follow"B"inthesafetyinformationaboveonthis
label.Ifyoudon'tsmellgas,gotothenextstep.
5. Turnwallswitch"ON".
6. If the Fireplace does not light, the System will cycle through
two trials, (one minute audible clicking, thirty seconds of
silence,andthenanotheroneminuteofaudibleclicking).
Ifthesystemlocksoutduetoinadequategasow,referto
"Troubleshooting",Page20.
7. After completion of the information in the Troubleshooting
section, Repeat step 5.
8. If the system will not function correctly, follow the instruc-
tions"ToTurnOffGasToAppliance"andcallyourservice
technician or gas supplier.
EV1 (Pilot
burner)
EV2 (Main
burner)
Pilot Adjust Screw
Lockout Reset Key
Diagnostic Terminal
Power
Command (Wall
switch)
Pilot Sensor
Igniter
Ground
EV1 (Pilot burner)
EV2 (Main burner)
Gas "Out"
Gas "In"
Incoming Gas
Line, Shut-off
Valve
To fireplace
Main burner
WARNING: If you do not follow these instructions exactly, a re or explosion may result
causing property damage, personal injury or loss of life.
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments