Montigo L52DF-ST Owner's Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
Page 15
L52DF(O)-ST See-thru Gas Fireplace
Part No. XG0711
f i r e f e a t u r
e
Maintenance
General
Q Have the replace and installation inspected yearly. The inspection
must include, but is not limited to, the following:
A visual check of the entire vent system and termination.
An inspection of the explosion relief appers and the door
gasketing to ensure a proper seal.
An inspection of the burner, venturi, and primary air openings.
Aninspectionofthegasvalve,gascomponents,andpilotame.
For your convenience a 1/8" manifold pressure tap is supplied
on the gas valve for a test gauge connection. See Figure 32.
Inspection of all optional equipment, thermostats, etc.
Q For Natural Gas this appliance requires a minimum inlet pressure
of 5.5" W.C. and a manifold pressure of 3.5" W.C.
Q For Propane Gas this appliance requires a minimum inlet pressure
of 11" W.C. and a manifold pressure of 10" W.C.
Q Alwayskeepthereplaceareaclearandfreeofcombustiblematerials,
aswellasgasolineandotherammablevaporsandliquids.
Q Do not use this appliance if any part has been under water. Immediately
callaqualiedservicetechniciantoinspecttheapplianceandto
replace any part of the control system and any gas control which
has been under water.
Operation
Lighting Instructions
See pages 12, 13 and 14.
Burner Adjustment
The L52DF-ST is equipped with an adjustable burner, allowing you to
raiseorlowertheames.Toadjusttheames,locatetheblackknob
marked 'Hi-Lo', in the centre of the gas control valve (See Figure 32).
The front burners are not adjustable.
Q Toraisetheameheight,turntheblackknob(locatedbehindthe
lower trim) counter-clockwise.
Q Tolowertheameheight,turnclockwise.
Figure 32. 'Hi-Lo' Adjustment on the L52DF-ST's gas valve.
Cleaning
Whenthereplaceisrstactivated,theremaybesomesmokingand
avisiblelmmaybeleftontheglass.Thisisanormalcondition,andis
the result of burning of protective coatings on new metal.
Q Glassmustbecleanedperiodicallytoremoveanylm(whichisa
normal by-product of combustion) which may be visible. Film can
easily be removed by removing the door, as shown on page 12.
Handle the door carefully, and clean it with non-abrasive glass
cleaners.OneofthemosteffectiveproductsisKelKem.
Q Siliconesealsoninnerdoorduringinitialringwill"offgas",leaving
a visual deposit of a white substance on combustion chamber walls.
This can easily be removed using normal household products.
Q Use a vacuum cleaner or whisk broom to keep the control
compartment,burner,andreboxfreefromdustandlint.
Q Linear Burners may be cleaned periodically with a vacuum to remove
soot or other contaminates.
Note: L52DF-ST-I models (electronic ignition) do not feature
hi/lo adjustment.
'Hi-Lo' Adjustment Knob
CAUTION!
Fireplacegascontrolmustbeinthe“OFF”positionandpilot
and main burners extinguished when cleaning appliance with
a vacuum.
Doors can get very hot. Handle only when cool.
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etch-
ing may cause premature glass failure.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments