Montigo H38DF PFC User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 38
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
Page 28
H*38DF PFC Peninsula Gas Fireplace
XG0816 - 150204.1
Operation
Operation
To Turn Off Gas To Appliance:
3. Push in gas control knob slightly and turn clockwise to
"Off". Do not force.
4. Replace the lower Horizontal access panel.
1. Turn off remote switch.
2. Lift out the lower Horizontal access panel.
Lighting Instructions:
1� STOP! Read the safety information above on this label.
2� Lift out the lower Horizontal access panel.
3� Push in gas control knob and turn clockwise
to "OFF."
4� Wait ve (5) minutes to clear out any gas. Smell for gas,
including near the oor. If you then smell gas, STOP! Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5� Locate pilot burner (See illustration at right.) and follow steps
below.
6� Turn knob on gas control counter clockwise
to "PILOT."
7� Push in gas control knob completely and hold. Light with Piezo
Igniter button. Continue to hold the control knob in for about
(1) minute after the pilot is lit. Release the knob and it will pop
back up. Pilot should remain lit. If it goes out repeat steps 3
through 8.
If knob does not pop up when released. Stop and immediately
call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control
knob to "OFF" and call your service technician or gas supplier.
8� Push in gas control knob and turn
counter-clockwise
to "ON."
9� Replace the lower Horizontal access
panel.
10� Turn on remote switch to ignite re.
NOTE: Gas control knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
Standing (Continuous) Pilot Ignition (SIT NOVA 820)
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
SIT Proame 2 Electronic Ignition
If you cannot reach your gas supplier, call the Fire Depart-
ment.
C. Use only your hand to push in or turn the gas control knob. Never
use tools. If the knob will not push in or turn by hand, don't try to
repair it, call a qualied service technician. Force or attempt to
repair may result in a re or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualied service technician to inspect the
appliance and to replace any part of the control system, and any
gas control which has been under water.
A. This appliance is equipped with an ignition system that lights the
pilot burner automatically. Do not attempt to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the oor because some gas is heavier
than air and will settle on the oor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in
your building.
Immediately call your gas supplier from a neighbour's phone.
Follow the gas supplier's instructions.
If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.
WARNING
WARNING/ CAUTION: Hot while in operation. Do not touch.
Severe burns may result. Keep children, clothing, furniture,
gasoline and other liquids having ammable vapours away.
See installation and operating instructions accompanying this
appliance.
Lighting Instruction Updates
Lighting Instruction UpdatesLighting Instruction Updates
Lighting Instruction Updates
Replace the warning label with danger label in the
Replace the warning label with danger label in the Replace the warning label with danger label in the
Replace the warning label with danger label in the
Lighting instructions
Lighting instructionsLighting instructions
Lighting instructions
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Comments to this Manuals

No comments